Subject	Unless you have a second maf that AFC is not going to
Posted by	Wright (Ca) on August 27, 2011 at 12:36 PM
	This message has been viewed 147 times.
In Reply To	Help Twin Pop upgrade posted by c300zxtt on August 27, 2011 at 10:01 AM
Message	do much for you. I am guessing you installed the twin pop kit with low speed drivability hose? Since you have only one maf the ecu is only seeing half the actual incoming air flow. You need to have the ecu reprogrammed to double that reading. To be honest though, your z most likely will not idle very well even if you did have the correct ecu programming. The best way to do a dual pop setup is to run two mafs and use either a afc or Selin translator to add/average the two signals. Good luck. Formerly: ZEVAN (Ca), Evan3zx(ca)
Follow Ups	Help Twin Pop upgrade - c300zxtt 10:01:17 08/27/11 Re: Help Twin Pop upgrade - c300zxtt 10:06:59 08/27/11 Unless you have a second maf that AFC is not going to - Wright (Ca) 12:36:13 08/27/11 Re: Unless you have a second maf that AFC is not going to - c300zxtt 13:31:33 08/27/11 If you add a second maf after the reprogram you will need - Wright (Ca) 13:53:18 08/27/11
Post a Followup	You cannot reply to this message because you are not logged in.