Subject	Having trouble setting base timing
Posted by	VoslickZ on August 26, 2011 at 11:00 AM
	This message has been viewed 144 times.
Message	I'm pretty sure I have everything hooked up right. The positive and negative leads are hooked up to the battery, and the clip is clipped the wires going to the coil pack on cylinder #1. Cylinder #1 is firing. Yet whenever I push the button for the strobe I don't see anything. The neighbor I borrowed the timing light from said he used it two days ago no problem. Is there anything that I'm doing wrong or is possible something is malfunctioning and not sending the timing light the signal? I'm trying to get it running so I can finish breaking it in before I leave, so thanks in advance.
Follow Ups	Having trouble setting base timing - VoslickZ 11:00:18 08/26/11 clipped *around* the wires (n/m) - VoslickZ 11:02:12 08/26/11 Check out this link... - DennisW (satx) 11:34:57 08/26/11 Thanks, I ended up going off of the PTU loop and - VoslickZ 11:46:27 08/26/11 Are your CAS bolts in the middle of the slots? (n/m) - Draker (Eugene, OR) 12:09:25 08/26/11 Yes. (n/m) - VoslickZ 13:37:25 08/26/11 1st time seeing that site, thanks for the new bookmark :) (n/m) - samsungz 13:52:40 08/26/11 Re: 1st time seeing that site, thanks for the new bookmark :) - jaidieray 17:29:57 08/26/11
Post a Followup	You cannot reply to this message because you are not logged in.