Subject	Re: When do you need to use a thicker-than-stock head gasket?
Posted by	jaidieray on August 24, 2011 at 7:07 PM
	This message has been viewed 143 times.
In Reply To	When do you need to use a thicker-than-stock head gasket? posted by DaZedMan on August 24, 2011 at 06:46 PM
Message	According to the fsm you can skim a total of .008thou off of the motor. If they skimmed .005 off of the heads then you still have .003 they could of removed if they had to (assuming your motor hasnt been skimmed prior). When rebuilding my motor the heads had to be skimmed .004 but not the block. The aluminum heads wear/distort easier than the block. You should be fine. [ http://300zx-twinturbo.com/cgi-bin/manual.cgi?list=em&dir=&config=&refresh=&direction=forward&scale=0&cycle=off&slide=52&design=default&total=70 ] 90na2tt swap KH2 charcoal 5spd 93tt 5spd AH3=sold 90na auto EJO=sold 06 spec v=sold 95 awd talon=sold
Follow Ups	When do you need to use a thicker-than-stock head gasket? - DaZedMan 18:46:29 08/24/11 Re: When do you need to use a thicker-than-stock head gasket? - jaidieray 19:07:47 08/24/11 Re: When do you need to use a thicker-than-stock head gasket? - CmyZ 19:08:52 08/24/11 thanks, guys. (n/m) - DaZedMan 19:34:17 08/24/11
Post a Followup	You cannot reply to this message because you are not logged in.