Subject	What'd be the best way to do that?
Posted by	idslave on August 22, 2011 at 1:56 PM
	This message has been viewed 116 times.
In Reply To	I would check the wiring from the harness to the ECU. (n/m) posted by Draker (Eugene, OR) on August 22, 2011 at 11:25 AM
Message	Put a multimeter on the harness side pin?
Follow Ups	constant knock - idslave 10:46:09 08/22/11 Re: constant knock - idslave 10:49:48 08/22/11 I would check the wiring from the harness to the ECU. (n/m) - Draker (Eugene, OR) 11:25:29 08/22/11 What'd be the best way to do that? - idslave 13:56:33 08/22/11 I would pull the ECU connector - Draker (Eugene, OR) 18:38:58 08/22/11 Are you sure your using a 1 mega ohm resistor? and - supermario680 22:20:24 08/24/11 yes (n/m) - idslave 15:23:46 08/28/11 Re: constant knock - AsaHerring 23:10:50 08/25/11 if you are going to get your ECU chipped - idslave 15:25:49 08/28/11 Re: if you are going to get your ECU chipped - AsaHerring 17:29:50 08/30/11
Post a Followup	You cannot reply to this message because you are not logged in.