Subject	Check to be certain the belts are centered their
Posted by	Gordo 93TT Daytona on August 20, 2011 at 11:47 AM
	This message has been viewed 125 times.
In Reply To	Accessory Belt Adjustemts..... posted by Havoc300 (Chicago) on August 20, 2011 at 09:38 AM
Message	respective pulleys. It sounds like a belt is one 'rib' off center. AFAIK no belt should be near the edge of another drive system's pulley. Not even close. Squeaking is almost always caused by either a worn belt (unlikely if you just replaced w/60k work), or a belt with too little tension. Lack of tension allows the belt to slip until it heats up and grabs the pulley surface. You state you have 'good' deflection. Is this your opinion, or have you measured it? The FSM is very specific on where and how to set the belt tension for each belt. _________________________________________________
Follow Ups	Accessory Belt Adjustemts..... - Havoc300 (Chicago) 09:38:23 08/20/11 Check to be certain the belts are centered their - Gordo 93TT Daytona 11:47:52 08/20/11 All belts are centered on their pulleys. The water pump - Havoc300 (Chicago) 13:15:38 08/20/11 Sorry...Here are some pics.... - Havoc300 (Chicago) 13:24:39 08/20/11 Those don't look like oem pulleys.. - 90GoldZ 14:09:40 08/20/11 I had same afterthought. Are you certain the parts - Gordo 93TT Daytona 14:49:53 08/20/11 No pulleys were replaced during the 60k... - Havoc300 (Chicago) 14:59:32 08/20/11 If the Crank pulley is seperating, and I replace, wouldn't - Havoc300 (Chicago) 15:08:55 08/20/11 Replacing the crank pulley - 90GoldZ 15:41:44 08/20/11 AAHHH, Now I get it. So then, As I drive for a few minutes.. - Havoc300 (Chicago) 17:28:38 08/20/11 Now you have a good excuse to get a UD/OD pulley setup. (n/m) - zellamay 21:17:16 08/20/11 Does the NA and TT share the same Crank Pulley? - Havoc300 (Chicago) 10:33:28 08/21/11 The point i was trying to get across was..... - 90GoldZ 07:45:03 08/23/11 Yeah..But it's not supposed to move at all... (n/m) - 90GoldZ 07:39:13 08/23/11 You may have the thick washer on the a/c idler pulley - ttz'in (NorCal) 05:24:26 08/24/11
Post a Followup	You cannot reply to this message because you are not logged in.