Subject	you shure the plates are completly closed when "of throttle"
Posted by	kickerzx on August 20, 2011 at 10:48 AM
	This message has been viewed 160 times.
In Reply To	setting throttle stops on z1 58mm cnc TB's posted by WazTTed on August 20, 2011 at 06:35 AM
Message	? I found my cruise control wire being to tight when i installed theese and kept the throttle a bit open.
Follow Ups	setting throttle stops on z1 58mm cnc TB's - WazTTed 06:35:18 08/20/11 you shure the plates are completly closed when "of throttle" - kickerzx 10:48:50 08/20/11 Re: you shure the plates are completly closed when "of throttle" - WazTTed 15:50:35 08/20/11 Re: setting throttle stops on z1 58mm cnc TB's - brian913 06:05:14 08/21/11 Re: Re: setting throttle stops on z1 58mm cnc TB's - WazTTed 06:28:33 08/21/11 Re: setting throttle stops on z1 58mm cnc TB's - ZTurboFan 23:12:16 08/22/11
Post a Followup	You cannot reply to this message because you are not logged in.