Subject	I think the rods are numbered in order...1-6, front to rear.
Posted by	91TTUSMC(FL) on August 20, 2011 at 8:49 AM
	This message has been viewed 111 times.
In Reply To	I don't know the history of the motor. I wouldn't be posted by Wright (Ca) on August 20, 2011 at 01:00 AM
Message	I am only basing this from tearing down a TT engine and an NA engine recently. The rods on both engines were marked 1-6, front to rear. This would lead me to assume that something has been done with your bottom end at some point and time unless there was a factory mess-up. Hopefully one of the experts will chime in. As far as the bearings, I'm not at the point of rebuilding yet but I am curious about the bearing grades as well as this is my first TT engine build. Good luck!
Follow Ups	Determining bearing grades...(long) - Wright (Ca) 17:51:08 08/19/11 Just found out that the pair of 1's are not zero's but - Wright (Ca) 18:02:33 08/19/11 According to the faq I should ignore the 1 that is stamped - Wright (Ca) 18:05:58 08/19/11 The FAQ is a bit vague when it comes to the rod bearings - ZXRider 23:15:54 08/19/11 I don't know the history of the motor. I wouldn't be - Wright (Ca) 01:00:31 08/20/11 I think the rods are numbered in order...1-6, front to rear. - 91TTUSMC(FL) 08:49:12 08/20/11 They should be 1-6 from the factory. - Woody75 (Denver) 14:30:21 08/23/11
Post a Followup	You cannot reply to this message because you are not logged in.