Subject	Re: Pulling an auto tranny
Posted by	txq45 on August 20, 2011 at 8:06 AM
	This message has been viewed 140 times.
In Reply To	Pulling an auto tranny posted by rojoloco (San Diego) on August 19, 2011 at 11:23 PM
Message	Don't have to move the transmission at all just remove dust cover. The 4 bolts that hold the torque converter to the flexplate are accessed there..You'll have to remove one bolt at a time and turn the flywheel to get the next one each time until all have been removed. With wiring and other bolts removed the transmission will seperate from the flexplate Nistune Dealer ECU socketing ECU eprom upgrades WWW.AAA-HiperformanceAuto.com
Follow Ups	Pulling an auto tranny - rojoloco (San Diego) 23:23:42 08/19/11 I don't know what you mean by pulling the bell housing - ZXRider 23:37:46 08/19/11 He's probably thinking there was a clearence issue - Sleeper_TTZ(SeKy) 04:32:01 08/20/11 How much heavier is the auto tranny from a 5 speed? - rojoloco (San Diego) 08:14:29 08/20/11 Never tangled with a Auto Z - Sleeper_TTZ(SeKy) 17:08:38 08/20/11 We managed to get a tranny jack. - rojoloco (San Diego) 21:00:54 08/20/11 Could you weigh the auto trans for future search's. - Sleeper_TTZ(SeKy) 16:38:50 08/21/11 Re: Pulling an auto tranny - txq45 08:06:13 08/20/11 5spd=75lbs, AT=roughly 200 lbs. Use a shop jack if u have to (n/m) - sandmanz32 09:25:51 08/20/11 Thanks for the help. We successfully pulled his motor. (n/m) - rojoloco (San Diego) 02:58:31 08/21/11
Post a Followup	You cannot reply to this message because you are not logged in.