Subject	He's probably thinking there was a clearence issue
Posted by	Sleeper_TTZ(SeKy) on August 20, 2011 at 4:32 AM
	This message has been viewed 118 times.
In Reply To	I don't know what you mean by pulling the bell housing posted by ZXRider on August 19, 2011 at 11:37 PM
Message	from the oil pan and maybe had to try and get extra room...Ratchet wrenches take care of that problem. The hardest part other than the weight to me would be keeping the motor from rotating while trying to break the bolts lose. 2nd the transmission jack, switching a 5 speed out is a pita, I wouldn't want to imagine dropping a auto trans by hand.
Follow Ups	Pulling an auto tranny - rojoloco (San Diego) 23:23:42 08/19/11 I don't know what you mean by pulling the bell housing - ZXRider 23:37:46 08/19/11 He's probably thinking there was a clearence issue - Sleeper_TTZ(SeKy) 04:32:01 08/20/11 How much heavier is the auto tranny from a 5 speed? - rojoloco (San Diego) 08:14:29 08/20/11 Never tangled with a Auto Z - Sleeper_TTZ(SeKy) 17:08:38 08/20/11 We managed to get a tranny jack. - rojoloco (San Diego) 21:00:54 08/20/11 Could you weigh the auto trans for future search's. - Sleeper_TTZ(SeKy) 16:38:50 08/21/11 Re: Pulling an auto tranny - txq45 08:06:13 08/20/11 5spd=75lbs, AT=roughly 200 lbs. Use a shop jack if u have to (n/m) - sandmanz32 09:25:51 08/20/11 Thanks for the help. We successfully pulled his motor. (n/m) - rojoloco (San Diego) 02:58:31 08/21/11
Post a Followup	You cannot reply to this message because you are not logged in.