Subject	I don't know the history of the motor. I wouldn't be
Posted by	Wright (Ca) on August 20, 2011 at 1:00 AM
	This message has been viewed 120 times.
In Reply To	The FAQ is a bit vague when it comes to the rod bearings posted by ZXRider on August 19, 2011 at 11:15 PM
Message	surprised if it has been worked on. Formerly: ZEVAN (Ca), Evan3zx(ca)
Follow Ups	Determining bearing grades...(long) - Wright (Ca) 17:51:08 08/19/11 Just found out that the pair of 1's are not zero's but - Wright (Ca) 18:02:33 08/19/11 According to the faq I should ignore the 1 that is stamped - Wright (Ca) 18:05:58 08/19/11 The FAQ is a bit vague when it comes to the rod bearings - ZXRider 23:15:54 08/19/11 I don't know the history of the motor. I wouldn't be - Wright (Ca) 01:00:31 08/20/11 I think the rods are numbered in order...1-6, front to rear. - 91TTUSMC(FL) 08:49:12 08/20/11 They should be 1-6 from the factory. - Woody75 (Denver) 14:30:21 08/23/11
Post a Followup	You cannot reply to this message because you are not logged in.