Subject	I don't know what you mean by pulling the bell housing
Posted by	ZXRider on August 19, 2011 at 11:37 PM
	This message has been viewed 174 times.
In Reply To	Pulling an auto tranny posted by rojoloco (San Diego) on August 19, 2011 at 11:23 PM
Message	You need to remove the lower transmission shields which gives you access to the torque convertor. With the shields removed you can remove the bolts for the torque convertor. I believe there are 4 bolts total that attach the flex plate to the torque convertor. With those removed, and all the transmission bolts removed, you can pull the transmission back and lower it. You want the torque convertor removed with the transmission, do not leave it on the engine like you would with a clutch assembly. Also, please make sure you guys have a tranmission jack. The automatic is heavy, someone can really get hurt if it falls on them. Good luck. Buy Zama Posters Here I have nightmares about that happening...I'd be the poor bastard you'd hear about on the news that gets killed by a softball-size chunk while spreading out my body over the hood and screaming "Nooo!" (Having a conversation about hail damage) - BradZ (FL) on March 25, 2005 at 9:56 PM Tell your friend that you could take a dump, light it on fire and that would be hotter shit than his car. Probes suck, that's just all there is to it. - 300ZXpert (someday) on April 04, 2005 at 11:35 PM P.S. You REALLY are on here at ALL hours! And I thought I was bad! :) - zmenon on August 16, 2005 at 3:06 AM LOL...2+2 drivers should grow mullets..."Business in the front...party in the back" ;) - BradZ (FL) on November 29, 2005 at 4:45 PM
Follow Ups	Pulling an auto tranny - rojoloco (San Diego) 23:23:42 08/19/11 I don't know what you mean by pulling the bell housing - ZXRider 23:37:46 08/19/11 He's probably thinking there was a clearence issue - Sleeper_TTZ(SeKy) 04:32:01 08/20/11 How much heavier is the auto tranny from a 5 speed? - rojoloco (San Diego) 08:14:29 08/20/11 Never tangled with a Auto Z - Sleeper_TTZ(SeKy) 17:08:38 08/20/11 We managed to get a tranny jack. - rojoloco (San Diego) 21:00:54 08/20/11 Could you weigh the auto trans for future search's. - Sleeper_TTZ(SeKy) 16:38:50 08/21/11 Re: Pulling an auto tranny - txq45 08:06:13 08/20/11 5spd=75lbs, AT=roughly 200 lbs. Use a shop jack if u have to (n/m) - sandmanz32 09:25:51 08/20/11 Thanks for the help. We successfully pulled his motor. (n/m) - rojoloco (San Diego) 02:58:31 08/21/11
Post a Followup	You cannot reply to this message because you are not logged in.