| CAS pin is there, i would get a cas error if it was out of allignment right? Rechecked all injectors. 1 reads 11.5, the rest are all between 12.4 and 12.6. Also tested at ECU side of harness and results were the same. I'm not sure how to perform a boost leak test, but would that cause my car not to start? :1. Pull off your CAS and check out the drive pin (on the CAS side and the cam side).
:2. Injector spec is between 10 and 14 ohms. Your car will still run, but any injectors over 14ohms will make the car run like crap.
:3. Did you perform a boost leak test (NAs can, too).
:Good luck with it, sounds like you've already ruled out a lot...
|
