Subject	Actually, I guess rattle is probably a better description.
Posted by	Attridge_300ZX on July 27, 2011 at 1:19 PM
	This message has been viewed 112 times.
In Reply To	Is it a clunk or a rattle? posted by ZiNnYc on July 27, 2011 at 08:02 AM
Message	What is the rubber finisher, and the CCB your talking about? I replaced my clutch and flywheel last year with the Speciality Z 5 puck, I'm pretty sure I didn't have the clutch fork or spring replaced, but I did have the ball, and pilot bushing replaced though. I just read the product description on the Speciality Z website, for the 5 Puck and it says "The only down side encountered is low RPM load or lugging that creates noise transfer of the drive-train". So I'm thinking that may be the problem then. To answer your other questions, when you let off of the gas, you can fell the shifter move a bit. and I've installed subframe spacers.
Follow Ups	Driveshaft clunk. I have a Z1 platinum 1 piece aluminum - Attridge_300ZX 21:05:31 07/26/11 Is it a clunk or a rattle? - ZiNnYc 08:02:05 07/27/11 Actually, I guess rattle is probably a better description. - Attridge_300ZX 13:19:31 07/27/11
Post a Followup	You cannot reply to this message because you are not logged in.