Subject	Besides all of the other good points mentioned all ready
Posted by	Wright (Ca) on July 26, 2011 at 4:21 PM
	This message has been viewed 111 times.
In Reply To	CAS is fully Clockwise after 60k? posted by Draker (Eugene, OR) on July 25, 2011 at 08:24 PM
Message	if your crank pulley is aftermarket you should verify the timing notch is correct. Formerly: ZEVAN (Ca), Evan3zx(ca)
Follow Ups	CAS is fully Clockwise after 60k? - Draker (Eugene, OR) 20:24:26 07/25/11 No changes after recount. - Draker (Eugene, OR) 21:01:56 07/25/11 Re: No changes after recount. - jaidieray 21:50:16 07/25/11 2nd (n/m) - CGDriven 21:55:47 07/25/11 Try timing from coil pack 1 - sak01 21:54:04 07/25/11 I have gone thru 3 different timing lights trying to get - LJZTT 10:18:13 07/28/11 ..... - 90GoldZ 21:56:22 07/25/11 & time from coilpack 1. - 90GoldZ 21:58:26 07/25/11 Datascan reads 15 degrees. - Draker (Eugene, OR) 22:24:02 07/25/11 You cant do that. - Woody75 (Denver) 22:27:48 07/25/11 ^^^ - 90GoldZ 22:33:22 07/25/11 Oh man.. You are totally right! (n/m) - Draker (Eugene, OR) 22:57:07 07/25/11 This is the info I've been missing! - Draker (Eugene, OR) 22:54:16 07/25/11 Which of the two should the car be set to? (n/m) - JMartz 07:39:35 07/26/11 You can only physcially set the CAS. - Woody75 (Denver) 08:39:04 07/26/11 Do you put both wires of the loop in the pick up - JMartz 09:47:32 07/26/11 There is only 1 wire. (n/m) - Woody75 (Denver) 10:30:28 07/26/11 With the car fully warmed up... - sak01 08:40:48 07/26/11 I set the timing with the loop to the mark - JMartz 07:36:43 07/26/11 read what Woody posted above, can't do it that way. (n/m) - BoneZ (MD) 06:22:39 07/28/11 Besides all of the other good points mentioned all ready - Wright (Ca) 16:21:16 07/26/11 Already compared pulleys. - Draker (Eugene, OR) 18:08:36 07/26/11 Even on the first coil I get multiple readings. You just - treese88 22:17:42 07/27/11
Post a Followup	You cannot reply to this message because you are not logged in.