Subject	Yes, it was a bit snug.
Posted by	Draker (Eugene, OR) on July 24, 2011 at 8:19 PM
	This message has been viewed 89 times.
In Reply To	Mine is a bit off the middle of the slot. posted by JMartz on July 24, 2011 at 05:37 PM
Message	I think I put a set of screw drivers in opposing sides and pried it free. The thing about the timing, is I counted the teeth at least 5 times with the engine on a stand. I mean, it's really the only thing left I can think of.. but I verified it. I verified the tensioner gap after rotating it a few times. Looks like I am going to break into it.
Follow Ups	Lagged idle response from idle: Part 4 - Draker (Eugene, OR) 13:51:07 07/24/11 Mine is a bit off the middle of the slot. - JMartz 17:37:07 07/24/11 Yes, it was a bit snug. - Draker (Eugene, OR) 20:19:41 07/24/11 With the lack of power you describe coupled with - JMartz 20:29:05 07/24/11 I tore it down just now. - Draker (Eugene, OR) 22:54:18 07/24/11 Tell us your findings. (n/m) - JMartz 07:54:46 07/25/11 I didn't find anything. - Draker (Eugene, OR) 13:34:46 07/25/11 Here are two guesses... - JMartz 15:52:28 07/25/11 I've swapped the MAF. - Draker (Eugene, OR) 16:23:43 07/25/11 I am running out of suggestions. - JMartz 19:01:33 07/25/11 59, 24, 45, 24 - Draker (Eugene, OR) 00:14:22 07/25/11
Post a Followup	You cannot reply to this message because you are not logged in.