Subject	Mine is a bit off the middle of the slot.
Posted by	JMartz on July 24, 2011 at 5:37 PM
	This message has been viewed 81 times.
In Reply To	Lagged idle response from idle: Part 4 posted by Draker (Eugene, OR) on July 24, 2011 at 01:51 PM
Message	Your analysis seems very logical, an improperly timed cam. I have a question for you: after removing all 3 bolts holding the CAS (the ones you remove to adjust the timing), I am unable to pull the CAS out. Did you experience this when doing the belt job?
Follow Ups	Lagged idle response from idle: Part 4 - Draker (Eugene, OR) 13:51:07 07/24/11 Mine is a bit off the middle of the slot. - JMartz 17:37:07 07/24/11 Yes, it was a bit snug. - Draker (Eugene, OR) 20:19:41 07/24/11 With the lack of power you describe coupled with - JMartz 20:29:05 07/24/11 I tore it down just now. - Draker (Eugene, OR) 22:54:18 07/24/11 Tell us your findings. (n/m) - JMartz 07:54:46 07/25/11 I didn't find anything. - Draker (Eugene, OR) 13:34:46 07/25/11 Here are two guesses... - JMartz 15:52:28 07/25/11 I've swapped the MAF. - Draker (Eugene, OR) 16:23:43 07/25/11 I am running out of suggestions. - JMartz 19:01:33 07/25/11 59, 24, 45, 24 - Draker (Eugene, OR) 00:14:22 07/25/11
Post a Followup	You cannot reply to this message because you are not logged in.