Subject	The SPI epoxy primer layed down smooth, but the Metalux
Posted by	evan_aggie on July 24, 2011 at 8:28 AM
	This message has been viewed 293 times.
In Reply To	Painters Requested - Sanding Advice Needed posted by evan_aggie on July 23, 2011 at 08:37 PM
Message	was much more difficult as it was extremely thin. I used a 1.5mm tip on the primer, and 1.4mm tip on the base coat, but maybe I should have used 1.3mm on the base coat. I tried dialing back the fluid flow for the base coat, but seemed so runny. I tried increasing the pressure, reducing the fluid. It's okay. It is just the engine bay. I just want the fender wells to look decent.
Follow Ups	Painters Requested - Sanding Advice Needed - evan_aggie 20:37:10 07/23/11 the paint has orange peel texture - s3trios 00:36:55 07/24/11 Yes, you have to buff after 2000 grit. Or clearcoat but - kkrofft (OH) 07:42:53 07/24/11 The SPI epoxy primer layed down smooth, but the Metalux - evan_aggie 08:28:36 07/24/11 Can you clarify if the base coat is single stage or requires - sak01 12:22:37 07/24/11 Metalux is not a single stage. SPI clear goes over. - evan_aggie 13:31:06 07/24/11
Post a Followup	You cannot reply to this message because you are not logged in.