Subject	I'm thinking you and whitepearl might have it
Posted by	BlackholeZ on July 20, 2011 at 6:19 PM
	This message has been viewed 90 times.
In Reply To	Not saying that this pertains to your situation, but posted by ZTicket(Dallas) on July 20, 2011 at 11:13 AM
Message	I'm getting a bit of oil smoke particularly when I am closed throttle high rpm (high vacuum) I was thinking this might be a valve seal/guide and the high vacuum is pulling more oil through. I need to take a look at the plug. -Dan "Capitalization is the difference between helping your Uncle Jack off a horse, and helping your uncle jack off a horse." "'she' also likes to swap since I think I am going to need to give her to woody again." - Dvlhntr "full alphabetic boost mode" - ChristopherTheOne "Two oil eating, angry, spinning triangles of death." - turtleboy on rotary engines
Follow Ups	Cyl 6 misses at idle only - BlackholeZ 11:37:04 07/19/11 Re: Cyl 6 misses at idle only - supermario680 11:49:50 07/19/11 BH, the Z is very complex and many things can - JMartz 13:12:23 07/19/11 forgot to mention, I have a new harness - BlackholeZ 13:30:49 07/19/11 Assuming everything else is in proper order... - JMartz 19:38:26 07/20/11 Also I just put the motor in - BlackholeZ 13:33:31 07/19/11 Compression check yet? (n/m) - Wright (Ca) 15:45:27 07/19/11 Haven't done that yet (n/m) - BlackholeZ 15:57:44 07/19/11 why not start with the easy things.... - supermario680 16:03:13 07/19/11 I will - BlackholeZ 16:41:38 07/19/11 Not saying that this pertains to your situation, but - ZTicket(Dallas) 11:13:38 07/20/11 I'm thinking you and whitepearl might have it - BlackholeZ 18:19:09 07/20/11 I've got the same problem on cyl 5, only at idle. - whitepearl 15:28:16 07/20/11
Post a Followup	You cannot reply to this message because you are not logged in.