Subject	Re: Hey Woody, removed shroud, fan and rad to gain access
Posted by	Onyxblue on July 19, 2011 at 5:06 PM
	This message has been viewed 109 times.
In Reply To	Hey Woody, removed shroud, fan and rad to gain access posted by JMartz on July 19, 2011 at 12:53 PM
Message	There is a low pressure sensor on the drier. You should get an ohm/voltmeter and start troubleshooting [ http://www.300zx-twinturbo.com/cgi-bin/manual.cgi?list=ha&dir=&config=&refresh=&slide=82&cycle=off&scale=0&design=default&total=168 ]
Follow Ups	Air conditioning question... - JMartz 10:06:56 07/19/11 Did you check the wire coming off of the compressor? - Woody75 (Denver) 10:20:44 07/19/11 Hey Woody, removed shroud, fan and rad to gain access - JMartz 12:53:41 07/19/11 Re: Hey Woody, removed shroud, fan and rad to gain access - Onyxblue 17:06:03 07/19/11 Thanks for the tip. - JMartz 19:24:32 07/19/11 I ran a ground to the frame as a temp fix. - ELDIABLO 10:52:24 07/21/11 you're probably overcharged unless you had a leak - aliaZ 22:28:19 07/20/11 stop guessing and throw some gauges on your system - aliaZ 17:25:29 07/19/11 Adding refigerant did not restart the compressor. (n/m) - JMartz 09:03:41 07/20/11 Figured out the problem... - JMartz 09:02:41 07/20/11 the same happened to my 240sx - aliaZ 22:26:31 07/20/11
Post a Followup	You cannot reply to this message because you are not logged in.