Subject	Air conditioning question...
Posted by	JMartz on July 19, 2011 at 10:06 AM
	This message has been viewed 133 times.
Message	It is summer in Ga. Not the time of year you want to be in a car w/o a/c. Yesterday I turned it on and just hot air came out. Today I investigated. Looking from above I can see the clutch is not engaging. Looked at the fuse Ok. Tested the relay, passsed. Placed a DVM on the a/c relay power pins and got signal. Looking at the manual there is nothing beetween the relay and the clutch. If refrigerant was low, there would be no signal to the energize the relay. My question is: Can the clutch be removed with the compressor in place? I am getting ready to do the 60,000 mile service, perhaps this was the best time fot the a/c clutch to fail. Your advice and suggestions are appreciated.
Follow Ups	Air conditioning question... - JMartz 10:06:56 07/19/11 Did you check the wire coming off of the compressor? - Woody75 (Denver) 10:20:44 07/19/11 Hey Woody, removed shroud, fan and rad to gain access - JMartz 12:53:41 07/19/11 Re: Hey Woody, removed shroud, fan and rad to gain access - Onyxblue 17:06:03 07/19/11 Thanks for the tip. - JMartz 19:24:32 07/19/11 I ran a ground to the frame as a temp fix. - ELDIABLO 10:52:24 07/21/11 you're probably overcharged unless you had a leak - aliaZ 22:28:19 07/20/11 stop guessing and throw some gauges on your system - aliaZ 17:25:29 07/19/11 Adding refigerant did not restart the compressor. (n/m) - JMartz 09:03:41 07/20/11 Figured out the problem... - JMartz 09:02:41 07/20/11 the same happened to my 240sx - aliaZ 22:26:31 07/20/11
Post a Followup	You cannot reply to this message because you are not logged in.