Subject	Yes, it will hold 650 rpm with the valve diabled.
Posted by	JMartz on July 15, 2011 at 5:42 PM
	This message has been viewed 137 times.
In Reply To	Does it set to 20% open, and idle around 650 when disabled? (n/m) posted by BoneZ on July 15, 2011 at 03:25 PM
Message	Not sure about the 20% you menion. Is it possible the aftermarket chip now driving the new injectors is programmed for 900 idle rpm?
Follow Ups	Setting the idle - JMartz 13:32:28 07/15/11 Throttle cable too tight? (n/m) - RVAZ 15:15:37 07/15/11 Throttle cable adjusted properly. Butterflys are - JMartz 17:44:26 07/15/11 Does it set to 20% open, and idle around 650 when disabled? (n/m) - BoneZ 15:25:36 07/15/11 Yes, it will hold 650 rpm with the valve diabled. - JMartz 17:42:20 07/15/11 Could be the EPROM - Stadsport (PHX) 20:08:18 07/15/11 That is where I'm thinking the problem lies. - JMartz 08:28:21 07/16/11 And the idle switch? (n/m) - Stadsport (PHX) 11:19:59 07/16/11 Where is this switch and what does it do? (n/m) - JMartz 14:47:39 07/16/11 Re: Where is this switch and what does it do? - Stadsport (PHX) 19:10:05 07/16/11 If you have conzult it shows you-IDK about other programs. (n/m) - BoneZ 22:30:51 07/15/11 I do have a ConZult. What is IDK? - JMartz 08:27:15 07/16/11 I Don't Know- IDK (n/m) - 90GoldZ 12:35:30 07/16/11 Beside the inlet controlled by the IACV, - JMartz 08:36:24 07/16/11
Post a Followup	You cannot reply to this message because you are not logged in.