Subject	Injector Flow check
Posted by	Z OLOGY on July 05, 2011 at 8:57 PM
	This message has been viewed 137 times.
Message	Just installed a new EFI harness and some Used Nismo 555 injector on my brothers car which i got off a TT.net member and the #1 cylinder is not firing. I ohm that injector and got 11.8 whiich is good. I switched the coil pack and still that cylinder is not firing. I checked both coil pack and injector connectors with a test light and got power. Is there anyway of checking the injector to see if its flowing right? I was wondering if maybe I squeezed the bottom o ring when I installed it, even thought I did use petroleum jelly and they went in pretty smooth. Any suggestions? I was also wonder if I could install just one OEM 370 cc injector just to see if it was a flow issue since I don't have an extra 555.
Follow Ups	Injector Flow check - Z OLOGY 20:57:31 07/05/11 Have you actually checked for spark on that cylinder? - Woody75 (Denver) 09:23:29 07/06/11 Re: Have you actually checked for spark on that cylinder? - supermario680 10:53:07 07/06/11 I did not check for spark, but I have done this in - Z OLOGY 13:37:45 07/06/11 Re: I did not check for spark, but I have done this in - supermario680 13:50:07 07/06/11 Brand new EFI harness.... and they said they have seen - Z OLOGY 16:09:39 07/06/11 NO SPARK.... just did what woody said and I got - Z OLOGY 16:33:54 07/06/11 Found it..... PTU plug was not in all the way... - Z OLOGY 17:12:35 07/06/11 Re: Found it..... PTU plug was not in all the way... - supermario680 08:50:44 07/08/11
Post a Followup	You cannot reply to this message because you are not logged in.