Subject	FWIW -- I like to remove the bleeder on the slave and
Posted by	jzack on July 05, 2011 at 6:31 PM
	This message has been viewed 147 times.
In Reply To	??? posted by white22sky on July 05, 2011 at 11:45 AM
Message	let it plop, plop out until a steady stream starts to flow. Close the valve and do a single "check bleed" right after that to make sure no bubbles are present. Then move up to the top point.... Of course, having a helper for the 1st part helps a lot too to make sure the reservoir stays full.
Follow Ups	pedal pressure ridiculously light - SaphireZ 10:22:28 07/05/11 ??? - white22sky 11:45:25 07/05/11 FWIW -- I like to remove the bleeder on the slave and - jzack 18:31:14 07/05/11 did you follow my advice in my previous post? - aliaZ 10:08:43 07/06/11 Re: pedal pressure ridiculously light - supermario680 10:28:51 07/06/11 Re: pedal pressure ridiculously light - supermario680 10:36:57 07/06/11 Re: pedal pressure ridiculously light - SaphireZ 00:10:48 07/09/11 Re: Re: pedal pressure ridiculously light - atomatiX 00:45:16 07/11/11 Re: pedal pressure ridiculously light - SaphireZ 22:50:59 07/09/11
Post a Followup	You cannot reply to this message because you are not logged in.