Subject	clutch pedal pressure loss when engine start frustrated
Posted by	SaphireZ on July 03, 2011 at 1:05 AM
	This message has been viewed 286 times.
Message	I have a 1993 300zx, i just replaced the slave cylinder fluid i bled the line at the bottom so only fluid comes out put the re-attached the line, i pump the clutch pedal i get a little pressure and then the second i start the car all pressure goes away.... the pedal still comes back up doesn't stick to the ground or anything but there is a huge difference between the engine running and engine not running. After i turn the engine off, a few pumps and the pressure is back. Any idea's?
Follow Ups	clutch pedal pressure loss when engine start frustrated - SaphireZ 01:05:16 07/03/11 Is your car a turbo? - Stadsport (PHX) 02:24:31 07/03/11 yes its turbo.. i hope i don't have a messed up clutch :( - SaphireZ 05:16:28 07/03/11 Not sure I understand what you are saying? Did you have the - jlag 04:54:51 07/03/11 Re: Not sure I understand what you are saying? Did you have the - SaphireZ 05:17:02 07/03/11 is the pedal pressure ridiculously light - aliaZ 07:32:05 07/03/11 Re: is the pedal pressure ridiculously light - SaphireZ 13:49:53 07/03/11 you may have a problem with your booster - aliaZ 08:48:47 07/04/11 Gordo's write up - 93DemonCar 11:35:57 07/03/11 I cant seem to get enough travel out of my clutch - Z-staffa 22:29:15 07/05/11
Post a Followup	You cannot reply to this message because you are not logged in.