Subject	pinched o-rings on the cylinders not firing would
Posted by	doug8867 on June 24, 2011 at 10:50 AM
	This message has been viewed 124 times.
In Reply To	Troubles after injector swap w/ plenum pull posted by halcyoncloud on June 24, 2011 at 08:54 AM
Message	seem to be a likely cause. Or possibly if the injectors are not fully seated. But in any event you'll need to pull the plenum to check them if you haven't dremeled your plenum previously to allow removal of the injectors with the plenum on.
Follow Ups	Troubles after injector swap w/ plenum pull - halcyoncloud 08:54:02 06/24/11 You pinched an O-Ring. Take the injector.... - HK'S Z 10:31:38 06/24/11 2nd. I've had this happen recently to me as well. (n/m) - Haasz32 11:49:06 06/24/11 Did you also install the Selin translator with your Selin-> - Bo (Houston) 10:35:29 06/24/11 Yeah and you may have contaminated your oil with all--> - Bo (Houston) 10:48:15 06/24/11 Re: Did you also install the Selin translator with your Selin-> - halcyoncloud 11:43:44 06/24/11 pinched o-rings on the cylinders not firing would - doug8867 10:50:38 06/24/11
Post a Followup	You cannot reply to this message because you are not logged in.