Subject	resolved
Posted by	ZiNnYc on June 11, 2011 at 11:49 AM
	This message has been viewed 231 times.
In Reply To	still looking for ideas posted by ZiNnYc on June 10, 2011 at 11:17 PM
Message	after pulling apart the entire alarm, resoldering connections back to stock, replacing the ignition switch, R&Ring the batt fusible link I found this after pulling my hair when everything didnt work The failure was a tiny hairline that for some reason did not reveal itself fully until after I pulled it out. The link was darker in color than the rest, but since I didnt see the hairline I skimmed over it and wasted a night. this is the SKD CONTL 30A fusible link, second green down from the blue. symptoms were no on position, and therefore no switched power accessories. Aftermarket alarm was tied into the ignition along with power, so it too went dead. thank you jzack, Crim, aliaZ, Greg D & doug8867 for the ideas
Follow Ups	still looking for ideas - ZiNnYc 23:17:06 06/10/11 A friend of mine broke down yesterday with the same issue - aliaZ 06:31:05 06/11/11 check the continuity of the blue fusible link by the battery - aliaZ 07:32:58 06/11/11 Pulling the blue fusible link - ZiNnYc 11:42:18 06/11/11 I wasn't clear from your last posting -- did the - jzack 09:09:27 06/11/11 It happened once and now cant get a restart. (n/m) - ZiNnYc 10:00:01 06/11/11 Have you contacted the company that installed the alarm? - doug8867 10:31:01 06/11/11 resolved - ZiNnYc 11:49:51 06/11/11 good to hear (n/m) - aliaZ 12:02:18 06/11/11 Thx for posting -- sure makes you wonder if this is just - jzack 20:43:25 06/11/11 no idea, but given aliaZs friends experience below - ZiNnYc 16:25:31 06/12/11 yep - aliaZ 07:26:26 06/12/11 That's life for you, do a ton of work then find a simple fix - Crim 09:37:17 06/12/11
Post a Followup	You cannot reply to this message because you are not logged in.