Subject	2nd. That's what I've used to get to those clamps.
Posted by	doug8867 on June 08, 2011 at 8:10 PM
	This message has been viewed 121 times.
In Reply To	1/4" sockets are highly under-rated, and your friend. posted by CoHPhasor on June 08, 2011 at 12:25 PM
Message	For the drivers side I had to wedge my hand/wrist down by my clutch master cylinder. You'll find the angle you need eventually, but you likely will end up with some scrapes on the wrist forearm area. :-) You might also need to use a short pivot extension on the ratchet if your clamp is at an odd angle, so that you can position your socket at the right angle. Hope that helps.
Follow Ups	Plenum pull question - turbo outlet pipes - RedKev 21:07:39 06/07/11 The boost leak write up has good info on tightening those up (n/m) - BoneZ 21:14:57 06/07/11 Have you ever heared of turbo clocking? I had the same probl - Bo (houston) 00:48:25 06/08/11 Re: Plenum pull question - turbo outlet pipes - johnbsz 05:44:10 06/08/11 1/4" sockets are highly under-rated, and your friend. - CoHPhasor 12:25:30 06/08/11 2nd. That's what I've used to get to those clamps. - doug8867 20:10:05 06/08/11 I was able to pull the plenum for a injector - JMartz 11:48:54 06/09/11
Post a Followup	You cannot reply to this message because you are not logged in.