Subject	Re: Looking for some quick local advice.
Posted by	ZTurboFan on May 26, 2011 at 6:34 PM
	This message has been viewed 85 times.
In Reply To	Looking for some quick local advice. posted by Aqualung on May 26, 2011 at 09:22 AM
Message	I always keep one [plenum gasket] in my tool drawer. But I wouldn't hesitiate to just use RTV by itself. I usually use small dabs of RTV to hold the gasket in place before I drop the plenum over top. Guess you're good to go anyhow...
Follow Ups	Looking for some quick local advice. - Aqualung 09:22:05 05/26/11 Dremel it if it isnt too late (n/m) - z-u-later 09:55:43 05/26/11 throttle suction valve - ZDZZ 23:36:49 05/28/11 Ball-Peen Hammers and gasket material - njz 10:13:33 05/26/11 I think without the OEM black rubber traces on the gasket - Jim (Selin Design) 11:55:58 05/26/11 Re: I think without the OEM black rubber traces on the gasket - njz 12:13:12 05/26/11 RTV it if you're in a rush, one of our local guys had a - Cap927(Boston) 10:13:39 05/26/11 UPDATE: I finally found one locally, all is good now! Thanks - Aqualung 13:02:11 05/26/11 Re: Looking for some quick local advice. - ZTurboFan 18:34:13 05/26/11
Post a Followup	You cannot reply to this message because you are not logged in.