Subject	Any suggestions on how to do that?
Posted by	BlackholeZ on May 26, 2011 at 12:02 PM
	This message has been viewed 85 times.
In Reply To	Correct. To do that you need to use pressure on the outlet>> posted by ZUL8TR on May 26, 2011 at 11:29 AM
Message	I'm trying to think what I could rig up to apply 60psi of oil to the engine. -Dan "Capitalization is the difference between helping your Uncle Jack off a horse, and helping your uncle jack off a horse." "'she' also likes to swap since I think I am going to need to give her to woody again." - Dvlhntr "full alphabetic boost mode" - ChristopherTheOne "Two oil eating, angry, spinning triangles of death." - turtleboy on rotary engines
Follow Ups	Pre-oiling a motor - BlackholeZ 13:17:26 05/25/11 Re: Pre-oiling a motor - Guapo 13:29:03 05/25/11 Perfect, thanks Guapo - BlackholeZ 15:45:16 05/25/11 Nice write up , i used it and it worked but >>> - xteam300tt 20:59:52 05/25/11 Correct. To do that you need to use pressure on the outlet>> - ZUL8TR 11:29:03 05/26/11 Any suggestions on how to do that? - BlackholeZ 12:02:26 05/26/11 Just a quick thought. Remove the oil filter> - ZUL8TR 13:59:18 05/26/11
Post a Followup	You cannot reply to this message because you are not logged in.