Subject	2nd get the print out.
Posted by	Draker (Eugene, OR) on May 24, 2011 at 2:28 PM
	This message has been viewed 88 times.
In Reply To	Need Some Help with Alignment Problem posted by darkmann on May 24, 2011 at 12:02 PM
Message	Also, FSM lists the toe 0 - .08. Not that .01 degree's on each side are going to make a difference visually. I would get the printout from the shop and verify the specs they set it to, to the FSM.
Follow Ups	Need Some Help with Alignment Problem - darkmann 12:02:25 05/24/11 You can see a lot by wrapping a string around the car - zellamay 13:30:49 05/24/11 did you get a print out of the alignment? - JRFITZ 14:02:24 05/24/11 2nd get the print out. - Draker (Eugene, OR) 14:28:22 05/24/11 Re: 2nd get the print out. - darkmann 14:37:38 05/24/11 Well not being able to see what you are seeing.. - Draker (Eugene, OR) 12:07:43 05/25/11 Re: Well not being able to see what you are seeing.. - darkmann 16:47:51 05/25/11 That's a good idea. Testing by wearing out a tire is the - zellamay 19:07:29 05/25/11 Re: That's a good idea. Testing by wearing out a tire is the - darkmann 11:53:42 05/26/11 Okay, I apologize for my sarcasm. You posted, with the - zellamay 02:27:43 05/27/11 Re: Okay, I apologize for my sarcasm. You posted, with the - darkmann 08:38:40 05/27/11 Numbers in range but toe in is at the range limit of >> - ZUL8TR 11:56:51 05/26/11
Post a Followup	You cannot reply to this message because you are not logged in.