Subject	they should be stamped, Grade on one side and cylinder
Posted by	Hoppy2 on May 22, 2011 at 8:52 AM
	This message has been viewed 88 times.
In Reply To	I forgot I have the online version! posted by Coldfusown on May 22, 2011 at 02:55 AM
Message	on the other, Make sure they go on the right rod in the right cylinder and go in correctly. I had all the grades stamped facing the pass side of the block, towards filter tree and cylinder #'s on the other side. I can only see an issue on the lower cylinder numbers if the bearing grade matches the cylinder #.. But I am no pro, Just finished my rod bearings myself. 2 Z's in the making!!
Follow Ups	So, I'm down to just a block! - Coldfusown 19:23:59 05/21/11 FSM? (n/m) - Draker (Eugene, OR) 20:39:32 05/21/11 Agree on FSM and... - ZTurboFan 21:24:05 05/21/11 I forgot I have the online version! - Coldfusown 02:55:15 05/22/11 they should be stamped, Grade on one side and cylinder - Hoppy2 08:52:50 05/22/11 Re: they should be stamped, Grade on one side and cylinder - Coldfusown 13:47:18 05/22/11
Post a Followup	You cannot reply to this message because you are not logged in.