Subject	Warm start up problem.
Posted by	300zx_2+2 on May 21, 2011 at 11:06 PM
	This message has been viewed 129 times.
Message	Car starts right up no problem when cold blooded. When the needle is in between c and h, check the timing 15dbtdc, shut it off to tighten the CAS and go to start it, it goes to 1000rpms then dies. Have to give it a little gas to get it to start. I honestly don’t have any clue as to where else to look or do. I’ve checked all connections, ohm’d coils, injectors, CAS, PTU, MAF. ECU doesn’t bring up any codes. Any help or advise would be greatly appreciated. -ZNOEVIL-
Follow Ups	Warm start up problem. - 300zx_2+2 23:06:32 05/21/11 May be the TPS is not set or bad. (n/m) - njz 09:08:39 05/22/11 What's the TPS suppost to be set at? (n/m) - 300zx_2+2 20:45:00 05/22/11 .45V - ZiNnYc 22:50:31 05/22/11 Nope, ive never had a problem with the TPS. So ive never had - 300zx_2+2 12:39:41 05/23/11
Post a Followup	You cannot reply to this message because you are not logged in.