Subject	600-650rwhp = deep pockets
Posted by	ba11erz on May 20, 2011 at 6:46 PM
	This message has been viewed 163 times.
In Reply To	which smic should i buy posted by triton117 on May 20, 2011 at 08:39 AM
Message	I'm sure you have it so here is a short list to achieve that goal: Stage III long block w/ JWT #500 Cams 2.5" intercooler piping ***Ash Massives*** Z1 58MM TBs Nismo 740cc MSP Mani SZ SS 3.0 DPs SZ 3.0 TP & CAT BACK 1pc Drive shaft NISTUNE or Zem Dyno tune by a Pro Even with all this, you still may be borderline 600rwhp on pump 93. As a lawyer would say…”It's doable but not practical if you want it to be a safe tune…it depends” ======================================== I too have the 675 and just peaked over 500rwhp on the dyno using 93 pump. I'm using Z1 SMICs with AshSpecZ 2.5" mod in/out piping. I feel like an #ERROR Id10ID10 now because the cost to mod them to 2.5” inlet/outlet put me over the cost of buying AshSpecZ Massives flat out. Doh!!! Do yourself a favor and buy the AshSpecZ Massives and 2.5" piping and larger Z1 TBs. For that kid of RWHP you're seeking, the input Air [MUST] have minimal restriction. Don't forget that exhaust flow (diameter) out should be equivalent or better to the Air flow (volume/diameter) in as a rule of thumb. I’m no expert so don't take my word for it; allow some of the real professionals to chime in. Good luck, and off you go! (recommend you get Ash Massives :)
Follow Ups	which smic should i buy - triton117 08:39:23 05/20/11 I have stillen's, and many other mods and only made 460whp - Hoppy2 10:10:37 05/20/11 Re: I have stillen's, and many other mods and only made 460whp - triton117 13:26:41 05/20/11 Simple Formula:V2 Massives X 2 + 2.5" FULL Piping= :-D (n/m) - samsungz 23:26:05 05/22/11 600-650rwhp = deep pockets - ba11erz 18:46:26 05/20/11 Nice list, except not sure what the DS has to do with it (n/m) - ZiNnYc 21:28:03 05/20/11 ^2nd - teejay407 08:39:48 05/21/11
Post a Followup	You cannot reply to this message because you are not logged in.