Subject	FWIW I use Bosch O2 sensors on an EFI System at work.
Posted by	BlackholeZ on May 17, 2011 at 10:26 PM
	This message has been viewed 193 times.
In Reply To	As pictured... posted by BOOZTD 3 on May 17, 2011 at 06:59 PM
Message	We cut off the stock connector and install our own, as short as 6". We have had no issues with the accuracy of the o2 sensor doing this. -Dan "Capitalization is the difference between helping your Uncle Jack off a horse, and helping your uncle jack off a horse." "'she' also likes to swap since I think I am going to need to give her to woody again." - Dvlhntr "full alphabetic boost mode" - ChristopherTheOne "Two oil eating, angry, spinning triangles of death." - turtleboy on rotary engines
Follow Ups	Wiring guru question - NobleZ 09:25:42 05/17/11 Re: Wiring guru question - ba11erz 10:49:13 05/17/11 Thank you guys, I will just try it and monitor the AFRs very - NobleZ 11:56:54 05/17/11 I dont see why not - BOOZTD 3 11:11:08 05/17/11 warning: you may have a problem with soldering the - njz 16:59:11 05/17/11 All of the bosch 'universal' o2's I've seen all use a crimp - BOOZTD 3 18:58:05 05/17/11 As pictured... - BOOZTD 3 18:59:45 05/17/11 FWIW I use Bosch O2 sensors on an EFI System at work. - BlackholeZ 22:26:24 05/17/11
Post a Followup	You cannot reply to this message because you are not logged in.