Subject	It should be more like .25"-.35"
Posted by	Draker (Eugene, OR) on May 15, 2011 at 2:51 PM
	This message has been viewed 115 times.
In Reply To	Re: Is your oil pan dented? That would cause low oil pressure posted by jaidieray on May 15, 2011 at 02:12 PM
Message	.1 might be too little.
Follow Ups	finally breaking in my motor - jaidieray 12:04:26 05/15/11 First, take a step back and relax. - Draker (Eugene, OR) 12:13:29 05/15/11 Re: First, take a step back and relax. - jaidieray 13:06:50 05/15/11 Is your oil pan dented? That would cause low oil pressure - J_Wright 13:42:13 05/15/11 Re: Is your oil pan dented? That would cause low oil pressure - jaidieray 14:12:59 05/15/11 It should be more like .25"-.35" - Draker (Eugene, OR) 14:51:08 05/15/11 If you had a spun bearing.. - Draker (Eugene, OR) 15:02:20 05/15/11 I'm with Draker at this point - CGDriven 15:08:22 05/15/11 Re: I'm with Draker at this point - jaidieray 15:35:57 05/15/11 It's a lifter or VTC. - Draker (Eugene, OR) 15:46:52 05/15/11 Re: It's a lifter or VTC. - jaidieray 16:29:01 05/15/11 Search on here and you'll find what you need. (n/m) - Draker (Eugene, OR) 16:48:41 05/15/11 sounds like you might have a few things going on - CGDriven 18:51:51 05/15/11
Post a Followup	You cannot reply to this message because you are not logged in.