Subject	TT Flexplate diameter?
Posted by	Cobra swe on May 14, 2011 at 9:16 AM
	This message has been viewed 439 times.
Message	As topic does anyone have a TT flexplate that you can measure, so I dont have to take the gearbox down, again.... Used the flexplate for support and the starter gear, to my new custom made flywheel so I can use a 7,25" 3-disc Tilton / Quarter Master Clutch. I assumed the TT flexplate and flywheel should've been the same diameter, guess I was wrong... Since the starter dosen't engage the ring gear properly. So just for confirmation I would like to know the diameter on the flexplate.. The flywheel is approx 12.6" tip->tip Thanks.
Follow Ups	TT Flexplate diameter? - Cobra swe 09:16:44 05/14/11 Re: TT Flexplate diameter? - ZTurboFan 00:34:56 05/15/11 Re: TT Flexplate diameter? - ZTurboFan 00:45:58 05/15/11 Re: Re: TT Flexplate diameter? - Cobra swe 08:47:56 05/15/11 Re: Re: Re: TT Flexplate diameter? - ZTurboFan 11:54:21 05/15/11 Re: Re: Re: Re: TT Flexplate diameter? - Cobra swe 13:40:56 05/15/11 Re: Re: Re: Re: TT Flexplate diameter? - Cobra swe 05:00:27 05/17/11 a tt flex plate has a NA flywheel diameter - Dane (Houston) 17:04:35 05/15/11 Re: a tt flex plate has a NA flywheel diameter - Cobra swe 23:52:43 05/15/11 240mm and 250mm are clutch disk diameters. - Joe@ZSpeedperformance 23:03:15 05/17/11 Ah! Thanks for clarification. (n/m) - ZTurboFan 00:59:41 05/18/11 My Measurements... - ZTurboFan 12:23:23 05/16/11 Re: My Measurements... - Cobra swe 05:52:52 05/17/11 Thanks for pics... - ZTurboFan 12:10:20 05/17/11
Post a Followup	You cannot reply to this message because you are not logged in.