Subject	I am pulling the motor, Not heads... will all be done on an
Posted by	Hoppy2 on May 14, 2011 at 6:44 AM
	This message has been viewed 112 times.
In Reply To	honestly you're asking for more work. posted by scottyfender on May 13, 2011 at 09:57 PM
Message	engine stand, just thru the oil pan, I dont want to tear the motor down at this time. I have deided against the rod bolts untill a later build. Thanks for the input. 2 Z's in the making!!
Follow Ups	Noisy rod bearing, How do I replace rod bolts? - Hoppy2 16:24:01 05/13/11 honestly you're asking for more work. - scottyfender 21:57:27 05/13/11 I am pulling the motor, Not heads... will all be done on an - Hoppy2 06:44:31 05/14/11 I wouldn't replace the bolts without resizing the rods - aliaZ 23:50:45 05/13/11 Was there a post here recently of someone replacing their - BoneZ 23:52:11 05/13/11 I've done that before (n/m) - aliaZ 08:25:34 05/14/11
Post a Followup	You cannot reply to this message because you are not logged in.