Subject	.
Posted by	ZiNnYc on May 09, 2011 at 10:19 PM
	This message has been viewed 131 times.
In Reply To	How do i set tps to .44v? posted by windex on May 09, 2011 at 09:38 PM
Message	[ http://www.twinturbo.net/net/viewmsg.aspx?forum=technical&msg_id=960871 ] PS... start searching run codes clean all connectors pull the second wire on cyl 1 coilpack as much as you can then place the inductive loop around that
Follow Ups	How do i set tps to .44v? - windex 21:38:06 05/09/11 . - ZiNnYc 22:19:33 05/09/11 Re: How do i set tps to .44v? - txq45 14:37:23 05/10/11 Here's some fish. - Stadsport (PHX) 15:10:46 05/10/11
Post a Followup	You cannot reply to this message because you are not logged in.