Subject	N/a motor replace issues
Posted by	windex on May 03, 2011 at 12:02 PM
	This message has been viewed 150 times.
Message	Ok im kina stuck, after reading some posts I will tell you whats going on. Ok I replaced my blown motor with a jdm motor. During the install I deleted the egr, aiv,and prvr. Now on startup it starts right up, hits 900 rpm for a few secs then idles down and dies. I disconnect tje maf and the car will stay idle. I replaced both temp sending units. When thottle is given with the maf and without the car dies. Was wondering what this is as this is my first Z. Any help with what to check I would greatly appreciate.
Follow Ups	N/a motor replace issues - windex 12:02:13 05/03/11 Re: N/a motor replace issues - windex 07:24:01 05/04/11 Did you set the tps to .44v ? check the timing ? - xteam300tt 07:55:38 05/04/11 Re: Did you set the tps to .44v ? check the timing ? - windex 19:25:14 05/04/11
Post a Followup	You cannot reply to this message because you are not logged in.