Subject	The oil seal at the far end near end the cover, right?
Posted by	evan_aggie on May 02, 2011 at 11:26 AM
	This message has been viewed 105 times.
In Reply To	Use a heat gun - this will soften the oil seal posted by Onyxblue on May 02, 2011 at 11:16 AM
Message	I just want to make sure we're on the same page. So, I just need to heat the aluminum housing around where the oil seal sits, or point the gun inside the housing itself? I guess I could try both. I'm never quite sure how much to attempt to heat something up via a heat gun like that. At least with the push-lock fuel hose the ends actually start smoking and then I knew it was hot enough. =)
Follow Ups	how do you remove the steering rack assembly (silver rod) !? - evan_aggie 20:23:33 05/01/11 Use a heat gun - this will soften the oil seal - Onyxblue 11:16:53 05/02/11 The oil seal at the far end near end the cover, right? - evan_aggie 11:26:34 05/02/11 done. (n/m) - evan_aggie 23:25:52 05/02/11 Heat gun helped? (n/m) - Onyxblue 10:17:56 05/03/11 Yes. Thanks. I tried heating the seal directly first, and - evan_aggie 13:42:37 05/03/11
Post a Followup	You cannot reply to this message because you are not logged in.