Subject	If you are working without a lift then a block of wood and a
Posted by	Jc (Houston) on April 29, 2011 at 5:48 AM
	This message has been viewed 232 times.
In Reply To	what were the lift points you used on the engine? (n/m) posted by blackomega on April 28, 2011 at 09:35 AM
Message	floor jack works well for lifting via the damper. If you were on a lift I would just use a highstand with the same method.
Follow Ups	possible to install BDE motor mounts with engine in the car? - blackomega 16:57:41 04/27/11 V1 or V2? V1 is supposed to fit with OEM mounts. (n/m) - Wright (Ca) 17:31:32 04/27/11 I'm thinking balls out, V2 (n/m) - blackomega 17:41:41 04/27/11 oh wait, V2 requires modifying compressor housing? - blackomega 18:06:23 04/27/11 You will have to lift the motor to remove the mounts anyway - -Grimm- 19:23:00 04/27/11 what were the lift points you used on the engine? (n/m) - blackomega 09:35:14 04/28/11 Not the right ones! - -Grimm- 10:33:55 04/28/11 haha, damn - blackomega 11:58:23 04/28/11 If you are working without a lift then a block of wood and a - Jc (Houston) 05:48:26 04/29/11
Post a Followup	You cannot reply to this message because you are not logged in.