Subject	You will have to lift the motor to remove the mounts anyway
Posted by	-Grimm- on April 27, 2011 at 7:23 PM
	This message has been viewed 223 times.
In Reply To	oh wait, V2 requires modifying compressor housing? posted by blackomega on April 27, 2011 at 06:06 PM
Message	I recently installed solid mounts. Just loosened the mounts, unbolted one side, lifted engine up as much as i could (with things still connected) and hammered out the old mount. New one slid right in, bolted it up, repeated for the other side.
Follow Ups	possible to install BDE motor mounts with engine in the car? - blackomega 16:57:41 04/27/11 V1 or V2? V1 is supposed to fit with OEM mounts. (n/m) - Wright (Ca) 17:31:32 04/27/11 I'm thinking balls out, V2 (n/m) - blackomega 17:41:41 04/27/11 oh wait, V2 requires modifying compressor housing? - blackomega 18:06:23 04/27/11 You will have to lift the motor to remove the mounts anyway - -Grimm- 19:23:00 04/27/11 what were the lift points you used on the engine? (n/m) - blackomega 09:35:14 04/28/11 Not the right ones! - -Grimm- 10:33:55 04/28/11 haha, damn - blackomega 11:58:23 04/28/11 If you are working without a lift then a block of wood and a - Jc (Houston) 05:48:26 04/29/11
Post a Followup	You cannot reply to this message because you are not logged in.