Subject	I'm thinking balls out, V2 (n/m)
Posted by	blackomega on April 27, 2011 at 5:41 PM
	This message has been viewed 203 times.
In Reply To	V1 or V2? V1 is supposed to fit with OEM mounts. (n/m) posted by Wright (Ca) on April 27, 2011 at 05:31 PM
Message
Follow Ups	possible to install BDE motor mounts with engine in the car? - blackomega 16:57:41 04/27/11 V1 or V2? V1 is supposed to fit with OEM mounts. (n/m) - Wright (Ca) 17:31:32 04/27/11 I'm thinking balls out, V2 (n/m) - blackomega 17:41:41 04/27/11 oh wait, V2 requires modifying compressor housing? - blackomega 18:06:23 04/27/11 You will have to lift the motor to remove the mounts anyway - -Grimm- 19:23:00 04/27/11 what were the lift points you used on the engine? (n/m) - blackomega 09:35:14 04/28/11 Not the right ones! - -Grimm- 10:33:55 04/28/11 haha, damn - blackomega 11:58:23 04/28/11 If you are working without a lift then a block of wood and a - Jc (Houston) 05:48:26 04/29/11
Post a Followup	You cannot reply to this message because you are not logged in.