Subject	I actually wondered the same thing: would the u-joint even
Posted by	evan_aggie on April 27, 2011 at 1:10 PM
	This message has been viewed 152 times.
In Reply To	Re: steering u-joint : is it okay to hammer off? posted by jaidieray on April 26, 2011 at 05:12 PM
Message	come off without unbolting the lower steering column that is attached to the top half of the u-joint. I wasn't entirely sure that the u-joint would slide up off of the steering rack given that steering column rod was only splined at the very end.
Follow Ups	steering u-joint : is it okay to hammer off? - evan_aggie 13:14:19 04/26/11 Re: steering u-joint : is it okay to hammer off? - rhombicblue 14:44:32 04/26/11 Re: steering u-joint : is it okay to hammer off? - jaidieray 17:12:55 04/26/11 I actually wondered the same thing: would the u-joint even - evan_aggie 13:10:56 04/27/11 Just grab it and start shaking the hell out of it - Noncon (STL) 18:30:39 04/26/11 This, they're a PITA but will come off with enough violence! (n/m) - Stadsport (PHX) 21:01:08 04/26/11 Yup, came off with a screw driver and some hammer strikes. (n/m) - evan_aggie 22:52:43 04/27/11 PB Blaster and a tap on top with flat head usually does it. - Milo (SATX) 13:10:06 04/27/11 Thanks. I need to post a few pics of the motor. It is - evan_aggie 13:56:40 04/27/11
Post a Followup	You cannot reply to this message because you are not logged in.