Subject	Helps, but the biggest reason I was looking..
Posted by	Stadsport (PHX) on April 25, 2011 at 10:13 PM
	This message has been viewed 128 times.
In Reply To	No pics, but measurements posted by ZiNnYc on April 25, 2011 at 09:04 PM
Message	Was I'm not sure how to remove the current mounts. Are there just tack welds holding it in place we can drill out? It looked pretty uniform last time I looked at them, so I wasn't quite sure where to drill (down towards the seam or forwards towards the side of the crossmember? Both?) Thanks for the reply though.
Follow Ups	NA>TT Conversion: Lower Radiator Mounts - Stadsport (PHX) 16:07:01 04/25/11 Just get this, works great - njz 16:56:09 04/25/11 Sorry won't work with stock tt rad. (n/m) - njz 17:04:06 04/25/11 No pics, but measurements - ZiNnYc 21:04:40 04/25/11 Helps, but the biggest reason I was looking.. - Stadsport (PHX) 22:13:41 04/25/11 Yep, jus tack welded on. Drill them out. (n/m) - Woody75 (Denver) 10:08:38 04/26/11 spot weld drill bit? (n/m) - ZonaZ 10:17:24 04/26/11 Either should work. - Woody75 (Denver) 07:46:46 04/27/11
Post a Followup	You cannot reply to this message because you are not logged in.