Subject	There is no substitute for a good tune.
Posted by	sparkie on April 25, 2011 at 3:55 PM
	This message has been viewed 127 times.
In Reply To	Is there a cure for spun rod bearing? posted by 91TTUSMC on April 24, 2011 at 10:15 AM
Message	1. Spun rod bearing isn't common. 2. You shouldn't worry about rod bearings as much as about having a good tune. www.ztechz.net ICQ # 14337317
Follow Ups	Is there a cure for spun rod bearing? - 91TTUSMC 10:15:37 04/24/11 it isn't that common if you boost sensibly, IMHO - aliaZ 11:05:39 04/24/11 Re: it isn't that common if you boost sensibly, IMHO - 91TTUSMC 12:03:57 04/24/11 I always figured it was a combo of high temps - ZiNnYc 12:17:38 04/24/11 that is true - aliaZ 07:06:43 04/25/11 also true. i have seem more melted knock sensors than i can - ztunerz 22:43:28 04/25/11 Yup (n/m) - John (MD) 13:54:15 04/29/11 Re: it isn't that common if you boost sensibly, IMHO - 91TTUSMC 23:46:07 04/25/11 There is no substitute for a good tune. - sparkie 15:55:46 04/25/11 agreed (n/m) - aliaZ 17:37:29 04/25/11 Re: Is there a cure for spun rod bearing? - Tech@EPR 21:20:09 04/26/11
Post a Followup	You cannot reply to this message because you are not logged in.