Subject	I've used a pickle fork and 3# sledge. (n/m)
Posted by	BoneZ on April 21, 2011 at 8:41 PM
	This message has been viewed 273 times.
In Reply To	outer tie rod removal - sledge hammer method??? posted by evan_aggie on April 19, 2011 at 10:31 PM
Message
Follow Ups	outer tie rod removal - sledge hammer method??? - evan_aggie 22:31:15 04/19/11 I have this, and it works great! - Draker (Eugene, OR) 22:47:51 04/19/11 thanks. I'll probably buy that and return the 3lb sledge. (n/m) - evan_aggie 23:05:10 04/19/11 Hit it harder! Seriously! Might have to apply light downward - Jc (Houston) 23:41:22 04/19/11 PB blaster, thread the nut on it a few turns and knock the - Sleeper_TTZ(SeKy) 00:10:21 04/20/11 I assume you mean for it to be hit on top? Isn't that bad? - evan_aggie 06:43:47 04/20/11 Just keep whacking it hard on side of control arm - sumonis 14:27:46 04/20/11 Well what are you removing it for. - Sleeper_TTZ(SeKy) 23:03:49 04/20/11 if you have an Autozone nearby... - aliaZ 06:19:29 04/20/11 I have and use that tool all the time. Works great. (n/m) - Woody75 (Denver) 07:57:49 04/20/11 I've used a pickle fork and 3# sledge. (n/m) - BoneZ 20:41:27 04/21/11 The problem with pickle forks is that they often destroy - aliaZ 06:33:48 04/22/11 True~ I was replacing them when I used this method. (n/m) - BoneZ 08:05:49 04/22/11 I prefer not to hit the Aluminum knuckles with a sledge - Joe@ZSpeedperformance 21:54:01 04/23/11 agreed (n/m) - aliaZ 07:57:50 04/24/11
Post a Followup	You cannot reply to this message because you are not logged in.