Subject	Re: Throttle Linkage and Position Adjustment After Z1 TB Install
Posted by	rhombicblue on April 19, 2011 at 12:48 PM
	This message has been viewed 253 times.
In Reply To	Throttle Linkage and Position Adjustment After Z1 TB Install posted by Drk93TT on April 18, 2011 at 01:31 PM
Message	Very helpful and well documented post. Up until recently, I was having problems with the TPS idle contacts not completely making contact following several WOT runs. When this happens, the idle goes up and stays around 1500 RPM. I think I finally positioned the TPS such that it reliably closes the TPS idle contact even when the engine/engine compartment is very warm.
Follow Ups	Throttle Linkage and Position Adjustment After Z1 TB Install - Drk93TT 13:31:37 04/18/11 Re: Throttle Linkage and Position Adjustment After Z1 TB Install - rhombicblue 12:48:12 04/19/11 Thanks, good luck with it! - Drk93TT 22:01:06 04/19/11 Sidenote: Last picture - Drk93TT 22:03:55 04/19/11
Post a Followup	You cannot reply to this message because you are not logged in.