Subject	here are some pics
Posted by	aliaZ on April 19, 2011 at 6:34 AM
	This message has been viewed 154 times.
In Reply To	Re: I built a tool out of square steel tubing posted by atomatiX on April 18, 2011 at 07:49 PM
Message	The tool I created looks like this: I slide it over the studs and MC push rod like this: It twists apart. Be careful not to bend the studs. Insert the tool so that it is as flush as possible to the booster shell. Here is the rubber reaction disc that has fallen out: Here is where I found my disc when I separated the shells of the booster. It is supposed to go in the middle hole: Here is the reaction disc installed behind the MC pushrod:
Follow Ups	Clutch Booster NOT OPENING - atomatiX 14:34:42 04/18/11 I built a tool out of square steel tubing - aliaZ 16:01:40 04/18/11 Re: I built a tool out of square steel tubing - atomatiX 19:49:12 04/18/11 here are some pics - aliaZ 06:34:15 04/19/11 I haven't done it yet, but... - thumper 23:41:21 04/18/11 Re: I haven't done it yet, but... - aliaZ 05:42:33 04/19/11 Thanks as usual aliaZ :) (n/m) - thumper 15:15:39 04/19/11 glad to help (n/m) - aliaZ 06:21:14 04/20/11
Post a Followup	You cannot reply to this message because you are not logged in.