Subject	I built a tool out of square steel tubing
Posted by	aliaZ on April 18, 2011 at 4:01 PM
	This message has been viewed 95 times.
In Reply To	Clutch Booster NOT OPENING posted by atomatiX on April 18, 2011 at 02:34 PM
Message	I drilled holes in it to match up to the master cylinder studs. This provided the necessary leverage to twist it apart
Follow Ups	Clutch Booster NOT OPENING - atomatiX 14:34:42 04/18/11 I built a tool out of square steel tubing - aliaZ 16:01:40 04/18/11 Re: I built a tool out of square steel tubing - atomatiX 19:49:12 04/18/11 here are some pics - aliaZ 06:34:15 04/19/11 I haven't done it yet, but... - thumper 23:41:21 04/18/11 Re: I haven't done it yet, but... - aliaZ 05:42:33 04/19/11 Thanks as usual aliaZ :) (n/m) - thumper 15:15:39 04/19/11 glad to help (n/m) - aliaZ 06:21:14 04/20/11
Post a Followup	You cannot reply to this message because you are not logged in.